Hi all,
I've been trying to get sound working on my TV card, but all I get is a
very short crack from my speaker when I load the saa7134 module. Line
out is directly connected into my monitor speaker for testing. This
setup is working with windows.
I'm using a plain vanilla kernel 2.4.21 and the latest snapshots for
v4l2 and saa7134. Everything seems to work perfectly fine, except sound!
It seems that audio isn't activated or unmuted for some reason. With
volume all the way up I hear some static noise from my monitor speaker.
When I load the modules all the noise is gone immediately. Suggestions
anyone? Tia.
Here's a picture (80kB) of the TV card if anyone is interested:
http://www.koorenneef.nl/cinergy400.jpg
Here's some output from loading the module:
saa7130/34: v4l2 driver version 0.2.9 loaded
PCI: Enabling device 02:0a.0 (0004 -> 0006)
PCI: Assigned IRQ 11 for device 02:0a.0
saa7134[0]: found at 02:0a.0, rev: 1, irq: 11, latency: 32, mmio: 0xf2000000
saa7134[0]: subsystem: 153b:1142, board: Terratec Cinergy 400 TV
[card=8,autodetected]
i2c-core.o: adapter saa7134[0] registered as adapter 0.
saa7134[0]: i2c eeprom 00: 3b 15 42 11 ff ff ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 10: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 20: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7134[0]: board init: gpio is 50000
i2c-core.o: driver i2c TV tuner driver registered.
tuner: chip found @ 0xc0
tuner: type set to 5 (Philips PAL_BG (FI1216 and compatibles))
i2c-core.o: client [Philips PAL_BG (FI1216 and comp] registered to
adapter [saa7134[0]](pos. 0).
saa7134[0]: registered device video0 [v4l2]
saa7134[0]: registered device vbi0
saa7134[0]/audio: audio carrier scan failed, using 5.500 MHz [default]
--
Wim Koorenneef <wim.at.koorenneef.dot.nl> rlu # 248659
"Change not the mass but change the fabric of your soul
and your own vision, and you will change all."
