Hi Robert, Put these lines somewhere in your modules.conf: options bttv card=64 tuner=2 and options tuner type=2 debug=1 This is a known problem with the ATI TV Wonder VE tuners. Anyways, with those lines you should be good to go! On Wed, 28 May 2003 09:37:13 -0500 "Robert W. Fuller" <microbus@xxxxxxxxxxx> wrote: > I'm in the US so I have NTSC. The bttv driver is chosing PAL. > Obviously, the video is very poor. Suggestions? Thank you. > > Linux video capture interface: v1.00 > bttv: driver version 0.7.106 loaded > bttv: using 32 buffers with 2080k (66560k total) for capture > bttv: Host bridge is VIA Technologies, Inc. VT82C693A/694x [Apollo PRO133x] > bttv: Host bridge is VIA Technologies, Inc. VT82C596 Power Management > bttv: Bt8xx card found (0). > bttv0: Bt878 (rev 17) at 00:12.0, irq: 18, latency: 32, mmio: 0xdf101000 > bttv0: detected: ATI TV Wonder/VE [card=64], PCI subsystem ID is 1002:0003 > bttv0: using: BT878(ATI TV-Wonder VE) [card=64,autodetected] > i2c-core.o: client [EEPROM chip] registered to adapter [bt848 #0](pos. 0). > i2c-core.o: adapter bt848 #0 registered as adapter 1. > bttv0: using tuner=19 > bttv0: i2c: checking for TDA9875 @ 0xb0... not found > bttv0: i2c: checking for TDA7432 @ 0x8a... not found > i2c-core.o: driver i2c TV tuner driver registered. > tuner: ignoring SMBus Via Pro adapter at 5000 i2c adapter [id=0x40002] > tuner: probing bt848 #0 i2c adapter [id=0x10005] > tuner: chip found @ 0xc0 > tuner: type set to 19 (Temic PAL* auto (4006 FN5)) > i2c-core.o: client [Temic PAL* auto (4006 FN5)] registered to adapter > [bt848 #0](pos. 1). > bttv0: PLL: 28636363 => 35468950 .. ok > bttv0: registered device video0 > bttv0: registered device vbi0 > > > -- > video4linux-list mailing list > Unsubscribe mailto:video4linux-list-request@xxxxxxxxxx?subject=unsubscribe > https://www.redhat.com/mailman/listinfo/video4linux-list