-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 > somebody once mentioned that the connections between the board and > the msp3400 chip are different on the pinnacle and the hauppauge > card? someone on this list talked about doing a little soldering > experiment but never returned to talk about the result, iirc. I'd > be > curious about > that. I'm also curious if this is why the btaudio driver loads fine on my Pinnacle TV Studio, but doesn't actually produce any sound. Does anyone actually have a Pinnacle card that works with btaudio? Here's part of dmesg: bttv: Bt8xx card found (0). bttv0: Bt878 (rev 17) at 00:04.0, irq: 20, latency: 32, mmio: 0xfeb01000 bttv0: detected: Pinnacle PCTV [card=39], PCI subsystem ID is 11bd:0012 bttv0: using: BT878(Pinnacle PCTV Studio/Ra) [card=39,autodetected] bttv0: i2c: checking for MSP34xx @ 0x80... not found bttv0: miro: id=18 tuner=2 radio=fmtuner stereo=no bttv0: using tuner=2 bttv0: i2c: checking for MSP34xx @ 0x80... not found bttv0: i2c: checking for TDA9875 @ 0xb0... not found bttv0: i2c: checking for TDA7432 @ 0x8a... not found tvaudio: TV audio decoder + audio/video mux driver tvaudio: known chips: tda9840,tda9873h,tda9874h/a,tda9850,tda9855,tea6300,tea6420,tda8425,pi c16c54 (PV951) tuner: probing bt848 #0 i2c adapter [id=0x10005] tuner: chip found @ 0xc2 tuner: type set to 2 (Philips NTSC (FI1236,FM1236 and compatibles)) bttv0: i2c attach [client=Philips NTSC (FI1236,FM1236 and ,ok] bttv0: PLL: 28636363 => 35468950 ... ok bttv0: registered device video0 bttv0: registered device vbi0 bttv0: registered device radio0 I know that the card has a MSP on it; big square chip; do any of the newer v0.7 drivers work any better? Here's what it looks like after modprobe btaudio: btaudio: driver version 0.7 loaded [digital+analog] btaudio: Bt878 (rev 17) at 00:04.1, irq: 20, latency: 32, mmio: 0xfeb00000 btaudio: using card config "default" btaudio: registered device dsp0 [digital] btaudio: registered device dsp1 [analog] btaudio: registered device mixer0 The video works fine, just no audio apparently. When I run sox and create a .wav file, dsp0 produces a 44 byte file that only has: "RIFF$WAVEfmt }udata" in it, and dsp1 creates a file that has silence. -----BEGIN PGP SIGNATURE----- Version: PGPfreeware 7.0.3 for non-commercial use <http://www.pgp.com> iQA/AwUBPnucAvc1NpCTlP0JEQJF0ACg+6Yp7L+12NAT+EBrhkLNGHns1LQAnR5O qy3MX72jJmaRPjsm8KTinVjh =7p+V -----END PGP SIGNATURE-----