Ole Andre Schistad wrote:
Perhaps I can edit this in the source instead - there are presumably a
set of generic scancodes used for a given button. Not sure where
though, pointers anyone?
saa7134-input.c. Look for the keytable:
static IR_KEYTAB_TYPE cinergy_codes[IR_KEYTAB_SIZE] ...
Alternatively, if only I could get lirc to recognize the remote all of
these would be gone. The CVS version is actually seeing the keypresses,
and I can record a config file with irrecord - it just doesn't work. Has
anyone had time to experiment with lirc's evdev support yet? The lirc
mailinglist is a vacuum on this subject - not a single thread discussing
these devices, so I suspect that v4l is the most active user (if any
exist) of this particular functionality.
I had little difficulty getting it working under lirc. I do use a
different video card though (flyvideo 3000), also I used a ready-made
config file - does the config file you record with irrecord look
reasonably correct?
I just tried creating a lircd.conf using irrecord - its quite difficult
to use due to the remote buttons getting interpreted as keystrokes. I
also found it difficult as I seem to have debug enabled and get screens
full of debugging information which makes it difficult to read what
irrecord says :). I got it to work by using irrecord to generate a basic
lircd.conf file, and then putting the codes in manually.
You might like to look at the attached lircd.conf, and see if it looks
anything like yours. Some of the codes should even be the same, as they
are just the keyboard codes the saa7134 input driver generates.
HTH,
David Atkinson.
begin remote
name flyvideo3000
begin codes
AIR_CATV 0x00010182
VIDEO 0x00010189
AUDIO 0x00010188
POWER 0x00010074
AV_SOURCE 0x000100b0
FULLSCREEN 0x00010174
STEREO 0x00010079
MUTE 0x00010071
VOLUME_UP 0x00010073
VOLUME_DOWN 0x00010072
CHANNEL_UP 0x00010192
CHANNEL_DOWN 0x00010193
RECALL 0x00010081
ENTER 0x00010060
1 0x0001004f
2 0x00010050
3 0x00010051
4 0x0001004b
5 0x0001004c
6 0x0001004d
7 0x00010047
8 0x00010048
9 0x00010049
0 0x00010052
end codes
end remote
