Hi: I have a FlyVideo 3000 listed as follows: 00:0f.0 Multimedia controller: Philips Semiconductors: Unknown device 7134 (rev 01) Subsystem: Unknown device 5168:0138 Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 16 min, 40 max, 136 set Interrupt: pin A routed to IRQ 9 Region 0: Memory at ffbef800 (32-bit, non-prefetchable) [size=1K] Capabilities: [40] Power Management version 1 Flags: PMEClk- AuxPwr- DSI- D1+ D2+ PME- Status: D0 PME-Enable- DSel=0 DScale=3 PME- I am currently running kernel 2.4.21 but am happy to upgrade to the latest 2.4.x kernel. I am a blind person so I'm not at all concerned with picture quality. I'm also not hugely bothered about whether or not I can get the OSS device working, as I use ALSA and getting the OSS driver for the SAA7134 and ALSA to play ball looks like a losing battle to me. All I want is to be able to get the sound of the TV signal to come out of the output connector on the card. If I can get the OSS device to work, then so much the better. I've seen discussion on here about which versions of V4L2 and SAA7134 drivers to use, but I'm not overly clear on what's best right now. Is the latest code the best or should I use an August snapshot as recommended by someone on here? The other thing I'm not clear on is which modules need to be loaded. I realise you need to load the I2C stuff and the video-dev modules, but I'm a bit stuck after that. Do you load just the SAA7134 and tuner modules for this card, or do I need to load either or both of the TDA9887 and tvaudio modules as well? I've not been able to figure this out from the limited documentation. Any help you can provide will be appreciated. Thanks, Geoff.