"Robert Kulagowski" <rkulagowski@xxxxxxxxxxxxx> writes: > > Probably. Do you get sound out of the line-out of the card? Of > > yes, is it stereo sound (assuming some TV station sending stereo, > > mtv for example)? > > Sound on the line out? Yes. Stereo? More difficult to tell. It > _sounds_ like it may be stereo, but it's difficult to determine. MTV > is currently not playing any videos that demonstrate stereo audio > very well. Too bad there's no tv station where a voice just sits > there and says, "left, left, left, right, right, right, both, both, > both" etc. > > > > Is this why I don't get btaudio > > > sound after loading the btaudio module? > > Might be related, yes. The msp34xx is one possible source for the > > digital audio input of the bt878. > > Ah. Is further troubleshooting dependant on me determining if the > line-out is correctly sending stereo? The difference between the pro and non-pro versions of the miro/pinnacle cards is that the "pro" ones have a msp3400 chip and the others don't. I suspect what happens is that the bttv driver doesn't find the msp34xx for some reason, thus handles the card as non-pro version. Which will work just fine, the only difference is that the sound routed to the line-out isn't the stereo signal from the msp34xx but the mono signal from the tuner chip. It isn't that obvious that the card isn't handled correctly because you will get sound, it just isn't a stereo signal ... Without msp34xx being programmed correctly the chances that btaudio works are close to zero. With msp34xx it might work, I don't know for sure. Are there any messages from the msp3400 module in the syslog? What happens if you try to load it manually? Gerd -- /join #zonenkinder