Hello, [2nd attempt to send this question :-] I have tv card ManliTV with chip SAA7130, tuner M-TV002, v4l2 patch applied to 2.4.19 kernel and "installed" on original RedHat 8.0 (with 2.4.18-14 kernel). I have tried all card=#, #=0..14 (in saa7134-0.2.6) with no other additional insmod param. (specifying e.g. tuner) and with the same result: No picture and, in some card=# (in particular, card=4), only noise/sound (I can tune with card=4). With xawtv (v.14-Feb-2003), I obtained no picture (black tv-screen), I can "tune" to obtain either noise or clear sound of TV stations which are available here in Prague. The tv-sound appears only when I choose "TV" as a source; xawtv starts as default in Overlay mode. When I choose "off" or "grabdisplay", axwtv replies with an "v4l2 i/o error". Moreover, xawtv _always_ ends with such "v4l2 i/o error" message (?). v4l-conf replies (with no error) that /dev/video0 is configured. scantv replies always "no station" in all frequencies even when I can hear sound in some of them. tvtime shows blue tv-screen only with the message "no signal" mplayer 0.90.rc4 shows green tv-screen, says "no audio" but it can tune the desired freq and switch-on the sound of the corresponding TVstation. It cannot switch-off the sound after exit. I have borrowed an analogue Hi8 camera, connect it to the composite input of my TV card and: The ONLY picture I obtained was with card=4 and mplayer with input=2 (mplayer says input=2 as "TV", but shows picture from the camera) [and no sound (I connected it into audio-input in my TV card and maybe I should connect it into the line input of my sound card)] xawtv and tvtime did not showed anything with the exception of their black and blue tv-screens, respectively. I installed M$Win98SE and DScaler (v4.1.5 have support for Manli MTV001 card) and DScaler (v4.1.6 have support also for Manli MTV002 card), they both work perfectly (in M$Win :-( Moreover, I looked into the source file of v4.1.6 in order to find some info about the tuner it automatically chooses when one choose "Manli MTV002 card" - it is LG TPI 8PSB12D Pal B/G but in the source file (which is originaly "taken" from bytesex.org/saa7134 linux driver :-) it is written: TUNER_LG_B11D_PAL //should be LG TPI 8PSB12D Pal B/G and I have found "it (has the same parameters" as tuner=29 also in saa7134-tuner specifications in saa7134-0.2.6. Hence, I add tuner=29 in /etc/modules.conf, BUT with the much worse result than without this tuner option (and with default tuner, i.e. Philips as I remember (?) ): I am able to tune, but I hear noise only, the picture-resilats are as bad as before :-( Have somebody any suggestion? Thanks Honza <eisner@xxxxxxxxxxx>