Hello, On Wed, Sep 04, 2002 at 09:37:07PM +0200, Barry wrote: > I'm still working on the problem of the Pinnacle PCTVpro card not tuning under > Linux and am looking for some more feedback. Basically, I think the problem > is caused (at least partially) by the tuner.o module losing contact with the > MT2032 tuner chip on the card. This occurs after any contact on the I2C bus > with the TDA9886 chip also located on the card. > > If anyone has any suggestions on how contact can be re-established with the > MT2032 I be very interested (FYI - even a 'shutdown -r' doesn't work, it > needs to be a full power reset). Exactly, I experience the same behavior, after a fresh cold reboot the MT2032 communicates, but every attempt after that fails. Enabling debugs in the i2c and tda9887 modules only seems to indicate that the i2c_write fails. I tried disabling 'miro_pinnacle_gpio' and inserting with bttv_gpio=1 as suggested by Gunter, but I did not see a noticeable difference. Any other suggestions as to how to proceed further? Best regards, -Christian
