Hi
I have the same card, except i'm on a redhat system. try going to the
developer's website and download the newest zoran drivers, and install
them after compiling the kernel. Then modprobe saa7110 and THEN modprobe
zoran and it should take a little time to load. then go ahead and play
around with xawtv, lavrec, zapping, and so forth.
Good luck
marcel
Stephen Johnson wrote:
hello and thanks in advance for any help offered.
i'm an intermediate-advanced debian user running 2.4.18 kernel.
however, i'm new to computer video capture.
i picked up a dc10plus pinnacle sys card(for analog capture)that came
with a studio av version 7 pack. i do have that other os loaded on a
partition for this and its working with pinnacle's drivers.
then i found out it's supported under linux, yeah! anyway, the driver
developer's site is a bit confusing to me, the card shows up in
lscpi(below)
02:0b.0 Multimedia video controller: Zoran Corporation ZR36057PQC Video
cutting chipset (rev 02)
Subsystem: Miro Computer Products AG DC10 Plus
Flags: bus master, fast devsel, latency 0, IRQ 3
Memory at d5800000 (32-bit, non-prefetchable) [size=4K]
but there's so many modules that seem to point to this config, so i
compiled in almost everything(as modules) related to video4linux,zoran,
and dc10 including all the i2c stuff. i tried loading different module
configs and nothing seems to work when using xawtv or anyting else. i'm
assuming i might need some special module params, which i've never done
before. also i'm not sure wich devices i need, the devices.txt file in
/usr/src/linux/Documentation says there are devices for dc10 /dev/dc100
/dev/dc101 ... at major 94 and v4l uses /dev/video0... on major 81. i
tried both and neither seems to work(using symlink /dev/video to each).
so probably has something to do with module params, right? any
suggestions?
thanks
