Has the issue with WinTV PVR audio been fixed? (Nothing comes from the line-out port on the card.) Refering to this thread: http://marc.theaimsgroup.com/?t=98873899000001&w=2&r=1 If not, then is there any further info I can provide before I return the board? Brian # uname -r 2.4.9-ac10-ipvs # modprobe bttv bttv_gpio=1 Linux video capture interface: v1.00 bttv: driver version 0.7.72 loaded bttv: using 2 buffers with 2080k (4160k total) for capture bttv: Bt8xx card found (0). PCI: Found IRQ 11 for device 00:0c.0 PCI: Sharing IRQ 11 with 00:0c.1 bttv0: Bt878 (rev 17) at 00:0c.0, irq: 11, latency: 32, memory: 0xe1000000 bttv0: subsystem: 0070:4500 => Hauppauge WinTV/PVR => card=10 bttv0: model: BT878(Hauppauge new (bt878)) [autodetected] bttv0: Hauppauge msp34xx: reset line init i2c-dev.o: Registered 'bt848 #0' as minor 2 i2c-core.o: adapter bt848 #0 registered as adapter 2. bttv0: Hauppauge eeprom: model=45231, tuner=Philips FM1236 (2), radio=yes bttv0: i2c: checking for MSP34xx @ 0x80... not found bttv0: i2c: checking for TDA9875 @ 0xb0... not found bttv0: i2c: checking for TDA7432 @ 0x8a... not found tvaudio: TV audio decoder + audio/video mux driver tvaudio: known chips: tda9840,tda9873h,tda9850,tda9855,tea6300,tea6420,tda8425,pic16c54 (PV951) i2c-core.o: driver generic i2c audio driver registered. i2c-core.o: driver i2c TV tuner driver registered. tuner: chip found @ 0xc2 bttv0: i2c attach [Philips NTSC] i2c-core.o: client [Philips NTSC] registered to adapter [bt848 #0](pos. 0). # lsmod chicken:/2/home/brian# lsmod Module Size Used by tuner 4752 1 (autoclean) tvaudio 8432 0 (autoclean) (unused) bttv 58800 0 (unused) videodev 4928 3 [bttv] agpgart 18464 3 (autoclean) NVdriver 659072 15 (autoclean) serial 45552 0 (autoclean) isa-pnp 28656 0 (autoclean) [serial] parport_pc 18928 1 (autoclean) lp 5632 0 parport 24992 1 [parport_pc lp] cmpci 30576 0 soundcore 4080 4 [cmpci] tulip 37248 1