> "VoodooTV FM/ VoodooTV 200 (EXPERIMENTAL)". > > >From the source code: > // msp34xx: init: chip=MSP3450G-B6, has NICAM support > // but then only: chip reset failed, penguin on i2c bus? Might be that they use the same trick as Hauppauge: connect the msp3400 reset pin to one of the gpio pins. If you get the gpio wrong then, it might be that the reset line is permanently active and thus the communication with the chip failes for obvious reasons ... > // Beware: GPIO strongly influences tv signal noise (try card=0 tuner=33)!? > // Beware: I have to select "tv norm=NTSC" in xawtv here in Germany to get > // a sharp, though no-colors(!?) picture with a bit of noise/offset. > // With "tv norm=PAL" my picture would be trippled and very noisy... pll config wrong? > NTSC-tester wanted (try "tuner=34", default would be 33 for PAL) ! Shouldn't be needed as the tuner gets passed VIDIOCSCHAN and thus knows which TV norm we are running from video_channel->norm. > Gerd, please ignore my previous patches and apply this: > http://home.t-online.de/home/gunther.mayer/gmdiff-bttv0773-MT2032-v2 0.7.74 released, with the first tuner patch included, but the Voodoo patches not (yet). Gerd -- Damn lot people confuse usability and eye-candy.