Eugene Kuznetsov wrote: > > Hello Wandered, > > Thursday, May 31, 2001, 8:27:50 PM, you wrote: > > WI> Just upgraded my box to Mandrake 8.0. This included XFree 4.0.3 and > WI> xawtv 3.49. When I attempt to invoke xawtv, I get sound but no > WI> picture. I also get the following error messages: > > WI> This is xawtv-3.49, running on Linux/i686 (2.4.3-20mdk) > WI> x11: 1280x1024, 32 bit/pixel, 0 byte/scanline > WI> WARNING: Your X-Server has no DGA support. > WI> WARNING: couldn't find framebuffer base address, try manual > WI> configuration ("v4l-conf -a <addr>") > > As far as I remember, XFree 4.0+ by default have DGA disabled. You > have to manually edit /etc/X11/XF86Config and enable DGA. Okay, I was able to do this, but now only root can run xawtv and get a picture. I attempted to set the uid on xawtv, but it won't start at all then and provides a message saying it can not be suid. Under my previous system (SUSE), xawtv had group video and my id was a member of that group. I'll go this route if necessary, but is there an easier way? > > -- > Best regards, > Eugene > mailto:divx@xxxxxxx or sparky@xxxxxxxxxxxxxxx > [Team GADGET] [Team Two Divided By Zero] [Team Hackzone.ru] > > NetZero Platinum > No Banner Ads and Unlimited Access > Sign Up Today - Only $9.95 per month! > http://www.netzero.net -- Until later: Geoffrey esoteric@xxxxxxxxxxxxxxxxx "Great spirits have always found violent opposition from mediocre minds. The latter cannot understand it when a man does not thoughtlessly submit to hereditary prejudices but honestly and courageously uses his intelligence." - Albert Einstein