Hi everybody, here's another question from a V4L newbie. I'm working on a custom board with V4L2 drivers running on it and videodevX, v4l_compat modules loaded. If I run a V4L application, I see that the same command is received twice from the driver, once with the V4L ioctl value (and usually I get errors on it) and then with the translated V4L -> V4L2 ioctl value (and now it's OK). This behaviour leads to a bad-functioning application, so I need to make it work correctly. I tried to change the order the modules are loaded, but with no effect, current one is: insmod videodevX.o insmod v4l2i.o insmod v4l2o.o insmod v4l_compat.o Any suggestion? Thanks in advance, Matteo. -- ---------------------------------------------------- Matteo Pampolini - Project Leader Residential Gateways & internet Appliances CiaoLAB eTechnology S.p.A. Email: matteo.pampolini@xxxxxxxxxxx Phone: +39.02.2303.3946 Fax: +39.02.2303.3289 "Linux is user-friendly. Just very selective about his friends..." ----------------------------------------------------
